1930 REO

 1930 REO
(photo record for work performed in, Invoice #8)

Photo 8-1a) Removal of parts for epoxy coating including front and rear floor pans, lower firewall pan, air-conditioner housing and seat pedestal box, rear seat riser, console assembly, steering column, vent door and mechanism, and rear valence panel.

Photo 8-2a thru 8-2d) The first photo shows lower firewall pan after I scrubbed half of it with a scuff pad and vinegar to clean and etch the metal. Right side is scrubbed, and left side is not. Photo shows how using vinegar (which contains acid) cleans and etches the sheet metal. There’s actually a lot more to it than this, and I will explain in next billing. Second photo shows the air-conditioner box lid being cleaned with a power rust buster. Third photo shows rear floor pan being cleaned. Forth photo shows underside of front floor pan which I cleaned and etched with scuff pads and vinegar.

Photos 8-3a & 8-3b) Photos show prep of rear valence panel. 

Photo 8-4a) Photo shows floor pans and other panels prepared and ready for epoxy coating.

Photo 8-5a thru 8-5d)  Photos show floor pans and other parts epoxy coated.

Photo 8-6a thru 8-6c) Photos show floor pans and other epoxy coated parts stored under the REO.

Photo 8-76a and 8-7b) A/c and other interior parts removed and stored during removal of floor pans and other parts.

Note: There are more parts to prep and prime. I will do them one batch at a time until all are done. 

THANK YOU, JERRY!